
9
Finally you can now set how you wish the controller to operate.
You can operate the controller in either Manual or Timer Mode, by pressing the button you can
toggle between these two modes.
Manual
Mode
Timer
Mode
In this mode the temperature set on the display is maintained 24
hours a day, i.e. no timing facility and therefore no ‘ ‘ displayed.
Whilst in manual mode, if you rotate the dial to level 1.0 then turn
the dial further anti-clockwise, the thermostat will switch off and
display ‘OFF’.
On the timer program, the controller switches on and off as pro-
grammed. With this mode you tell the controller at what time of day
you want a warm fl oor and then using its intelligence,the controller
learns how long your fl oor takes to warm up.
Step 10
Step 11
Step 12
Step 13
Step 14
Step 15
Step 16
Enter timer
mode
Select fi rst day
First start time
First end time
Continue
Save program
Set fl oor level
Press and hold button until is displayed in
bottom right corner.
Rotate button to display the fi rst day you wish to
program and then press button.
Rotate button to indicate the start of the fi rst time
period when you want a warm fl oor (i.e. 06:00) and
then press the button.
Rotate button to highlight duration of fi rst warm
fl oor period, then press button to indicate the end
of fi rst time period (i.e. 07:30).
Rotate button to indicate next warm fl oor start time,
press the button, rotate to the end of the period
and press button again. Continue this through the
whole week.
To save programs, press and hold the button to
return to the normal display. By pressing the button
once you can now toggle between manual and
timer modes.
The button now controls the heat level of your
Devimat
™
system. The controller can be adjusted
to the required heat level on a range from 1-
10, level 10 being the maximum fl oor heat.
The displayed heat level is what the controller
will provide at the times programmed. It is
recommended that you initially set to level 5, then
adjust to suit.
5.0
5.0
1 2 3 4 5 6 7
07:30
1
22:30
1
5.0
06:00
1
Komentarze do niniejszej Instrukcji