DEVI devireg 550 Podręcznik Użytkownika Pobierz pdf (Strona 3)

Installing the Devimat

™

1. Draw up a plan of the room and

calculate the free ﬂ oor area.

Use the plan to work out how to

lay the mat evenly across the

ﬂ oor and show the location of the

cold tail (where the mat starts),

ﬂ oor sensor and connection box.

The Devimat

™

should laid avoiding all ﬂ oor

obstructions and close ﬂ oor ﬁ tting objects like pipes,

baths and cupboards. It is acceptable to lay the

devimat under suspended cupboards and wash

basins.

2. Mark the positions of the ﬂ oor ﬁ tting objects that

will be installed once the ﬂ oor is ﬁ nished, so

when laying the mat these can be avoided.

3. Each mat is supplied with a piece of 10mm

ﬂ exible tubing (only one tube is required for each

thermostat), this is for the ﬂ oor sensor, so that in

the unlikely event that the sensor fails, it can be

easily removed and

replaced without lifting the ﬂ oor.

In some situations a small channel may have to be

made in the ﬂ oor to accommodate the tubing. If so,

cut a channel from the thermostat position

approximately 20-30cm across the ﬂ oor.

It is important that the

channel is positioned such

that it lays between two

heating wires and not across

them and not above heating

pipes below the ﬂ oor. The

4. The existing ﬂ oor

should be prepared as normally

required for tiling, this may

include cleaning and

removing all loose particles,

removing any sharp

protrusions that may cause

damage to the heating wire,

priming the ﬂ oor surface and

bracing a timber ﬂ oor with WBP

ply-for professional guidance refer to your adhesive

manufacturers recommendations.

end of the tubing in the ﬂ oor

is sealed with tape to prevent

adhesive entering the tube.

1 2 3 4 5 6 7 8 ... 11 12

Komentarze do niniejszej Instrukcji

Brak uwag

DEVI devireg 550 Podręcznik Użytkownika Strona 3

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Termostaty DEVI devireg 550